On-Line Automatic X-Ray Seam Scanner
non-destructive measure method
Product portfolio search
Detection object:
Test items:
Testing occasions:
Home / Products List / CanNeed-MDER-10 Multi-station Digital Enamel Rater for Ends

Multi-station Digital Enamel Rater for Ends

Testing occasions:laboratory
Detection object:Metal cap/crown cap/tab cap/screw cap/claw opening cap
Test items:Paint film/paint/coating


CanNeed-MDER-10 Multi-station Digital Enamel Rater For Ends is used to test the integrity of the inner coating (inner coating density and current value) of the 10 ends at one time. If the inner coating is incomplete and the contents will corrode the metal and affect the quality and storage of the product.

Place ends into the opening hole of ten-hole fixing holders. After the ends are pressed, turn the ten-hole fixing holders over. The current values (mA) of each end as well as the maximum current value and average value can be read out in 4 seconds. If any test failure resulted from bad connection between the contacts, the corresponding position number of the ends will be shown on the screen. 


  • CanNeed-MDER-10 can finish testing the current of 10 ends in 4 seconds. If connected with two ten-hole fixing holders, it can test 20 ends at one time
  • High efficiency,efficiency raised by 66%
  • The data can be transmitted to the computer via RS232 C

Technical Parameter

  • Measuring Voltage: 6.3 V
  • Measuring Range: 0-300mA
  • Resolution: 0.01mA
  • Accuracy: +/- 5%
  • Data Port: RS232C
  • Dimension:L700*W370*H300mm

Related Products